Again with the mill type thing

Yesterday, Sunday, I got the opportunity to cut out some parts on our nice new mill we got last week. It’s fast.

So far, we’ve been running the mill with just spraying with WD-40 as a coolant, but once we get actual coolant running across the tool, we can cut even faster than with just WD-40.

The hard part of making a drain to recycle the coolant is mostly complete, Mr. Prelesnik, a fabrication mentor put in a drain hole, through the shower vinyl that covers the table the mill rests on.

Leave a Reply

Your email address will not be published. Required fields are marked *